

| Parameter | Value |
|---|---|
| Depth | 146 mm |
| Width | 61 mm |
| Height | 126 mm |
| Altitude | ≤ 2000 m |
| Insulation | Reinforced insulation |
| Product type | Relay Module |
| Mounting type | DIN rail mounting |
| With components | yes |
| Pollution degree | 2 |
| Connection method | IDC/FLK pin strip |
| Mounting position | any |
| Notes on operation | For proper use, the specifications of the installation directive (see Downloads) must be observed. For applications or use with third-party products, the specifications, and the safety and warning instructions of the respective third-party manufacturer must also be met. |
| Number of positions | 14 |
| Rated surge voltage | 6 kV (1.2/50 μs) |
| Degree of protection | IP00 |
| Overvoltage category | III |
| Number of connections | 1 |
| Standards/regulations | DIN EN 50178: 1998-04 |
| Contact switching type | Single contact, 1 changeover contact |
| Nominal input voltage UN | 24 V DC (±10 %) |
| Rated insulation voltage | 260 V |
| Maximum switching voltage | 150 V AC/DC (Maximum switching voltage of 230 V AC: the maximum switching voltage of 230 V is only permitted if the same fuse circuit is used. The outputs are not suitable for switching different outer conductors.) |
| Conductor cross section AWG | 24 ... 12 |
| Limiting continuous current | 4 A |
| Typical input current at UN | 200 mA (200 mA supply / ≤ 20 mA input current per signal) |
| Conductor cross section rigid | 0.2 mm² ... 2.5 mm² |
| Ambient temperature (operation) | -20 °C ... 50 °C |
| Conductor cross section flexible | 0.2 mm² ... 2.5 mm² |
| Connection in acc. with standard | IEC 60603-13 |
| Degree of protection (Installation location) | ≥ IP54 (Installation location) |
Technical specifications and performance data
Installation and operation guide