

| Parameter | Value |
|---|---|
| 6 kV (Safe isolation and reinforced insulation between input circuit and output contact paths) | |
| Color | green (RAL 6021) |
| Depth | 62 mm |
| Pitch | 2.54 mm |
| Width | 285.5 mm |
| Height | 112 mm |
| Product type | Interface module |
| Screw thread | M3 |
| Assembly note | in rows with zero spacing |
| Mounting type | DIN rail mounting |
| Operating mode | 100% operating factor |
| No. of channels | 32 |
| With components | yes |
| Article revision | 06 |
| Contact material | AgNi |
| Pollution degree | 2 |
| Stripping length | 8 mm |
| Connection method | IDC/FLK pin strip |
| Mounting position | any |
| Suitable I/O card | QY82P |
| Notes on operation | For proper use, the specifications of the installation directive (see Downloads) must be observed. For applications or use with third-party products, the specifications, and the safety and warning instructions of the respective third-party manufacturer must also be met. |
| Protective circuit | Free-wheeling diode (integrated in relay) |
| Input voltage range | 21.6 V DC ... 26.4 V DC |
| Number of positions | 50 |
| Rated surge voltage | 4 kV (Basic insulation between output contact current paths) |
| Degree of protection | IP00 |
| Overvoltage category | III |
| Typical release time | 6 ms |
| Number of connections | 1 |
| Standards/regulations | DIN EN 50178 |
| Typical response time | 9 ms |
| Contact switching type | 1 changeover contact |
| Min. switching current | 10 mA |
| Status display present | Yes |
| Status display/channel | Yellow LED (integrated in relay) |
| Type of switch contact | Single contact |
| Mechanical service life | 5x 106cycles |
| Nominal input voltage UN | 24 V DC |
| Rated insulation voltage | 260 V AC |
| Maximum switching voltage | 250 V AC/DC |
| Minimum switching voltage | 12 V AC/DC |
| Operating voltage display | Green LED |
| Conductor cross section AWG | 24 ... 12 |
| Limiting continuous current | 5 A |
| Typical input current at UN | 18 mA |
| Conductor cross section rigid | 0.2 mm² ... 4 mm² |
| Ambient temperature (operation) | -20 °C ... 50 °C |
| Conductor cross section flexible | 0.2 mm² ... 2.5 mm² |
| Interrupting rating (ohmic load) max. | 120 W (24 V DC) |
| Input voltage range in reference to UN | 0.9 ... 1.1 (observe derating) |
| Ambient temperature (storage/transport) | -20 °C ... 70 °C |
Technical specifications and performance data
Installation and operation guide