

| Parameter | Value |
|---|---|
| • WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible. | |
| Coding | B |
| Shielded | yes |
| Cable type | PROFIBUS [915] |
| Safety note | WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property. |
| Thread type | M12 |
| Cable length | 2 |
| Cable weight | 74 kg/km |
| Product type | Circular connectors (device side) |
| Mounting type | Rear wall/screw mounting M16 x 1.5 |
| Overall twist | 2 wires, twisted |
| Seal material | FKM |
| AWG signal line | 24 |
| Article revision | 13 |
| Contact material | CuZn |
| Flame resistance | according to IEC 60332-1 |
| Tensile strength | ≤ 100 N |
| Connection method | Bus line |
| Resistance to oil | Resistant to mineral oils and grease |
| Conductor material | Bare Cu litz wires |
| Contact resistance | ≤ 3 mΩ |
| Nominal current IN | 4 A (Plug/socket in accordance with IEC 61076-2-101, cable technical data is to be observed) |
| Nominal voltage UN | 48 V AC |
| Order information: | Lock nut is included in the scope of delivery |
| Single wire, color | red, green |
| Conductor structure | 1x2xAWG24/19 |
| Degree of pollution | 3 |
| Max. bending cycles | 3000000 |
| Number of positions | 5 |
| Rated surge voltage | 1.5 kV AC |
| Working capacitance | 28 nF (at 1 kHz) |
| Degree of protection | IP67 (When plugged in) |
| No. of cable outlets | 1 |
| Overvoltage category | III |
| Insulation resistance | ≥ 10 GΩ |
| External sheath, color | blue |
| Nominal voltage, cable | ≤ 100 V |
| Outer sheath, material | PUR |
| Test voltage Core/Core | 3600 V DC |
| Conductor cross section | 0.25 mm² |
| Contact connection type | Socket |
| External cable diameter | 8.00 mm ±0.4 mm |
| Optical shield covering | 70 % |
| Thickness, outer sheath | approx. 0.80 mm |
| Contact carrier material | PA 6.6 |
| Contact surface material | Ni/Au |
| Material wire insulation | Foamed PE |
| Standards/specifications | according to IEC 61076-2-101 |
| Material for screw connection | Zinc die-cast, nickel-plated |
| Wire diameter incl. insulation | 2.56 mm |
| Ambient temperature (operation) | -40 °C ... 80 °C (Cable, flexible installation) |
| Conductor structure signal line | 19x 0.14 mm |
| Dynamic load capacity (bending) | Max. bending cycles: 3000000, Bending radius: 60 mm, Acceleration: 4 m/s² |
| Flammability rating according to UL 94 | V0 |
| Minimum bending radius, flexible installation | 5 x D |
| Smallest bending radius, movable installation | 40 mm |
Technical specifications and performance data
Installation and operation guide