

| Parameter | Value |
|---|---|
| 0.8 Nm (Connector with coupling sleeve) | |
| Width | 19 mm |
| Coding | D |
| Height | 19 mm |
| Length | 61 mm |
| General | This product corresponds to the PROFINET Cabling and Interconnection Technology Guideline for PROFINET regulations, version 2.00, order no: 2.252, Chapter 8.2 Connectors for Outside Environment (Balanced cabling) |
| Shielded | yes |
| Application | Data |
| Head design | Plug |
| Sensor type | PROFINET |
| Cable outlet | straight |
| Product type | Circular connector (cable-side) |
| Assembly note | NOTE:Observe the permissible bending radii when routing cables, since the degree of protection may be at risk if the bending forces are too high. Reduce mechanical loads upstream of the connector, e.g., by using cable ties. |
| Seal material | Neoprene |
| Contact material | CuSn |
| Diameter housing | 19 mm |
| Head thread type | M12 |
| Outside diameter | 4 mm ... 8 mm |
| Connection method | Insulation displacement connection |
| Head cable outlet | straight |
| Tightening torque | 0.4 Nm (M12 knurl) |
| Contact resistance | ≤ 5 mΩ |
| Nominal current IN | 1.75 A |
| Nominal voltage UN | 48 V AC |
| Degree of pollution | 3 |
| Dimensional drawing | |
| Number of positions | 4 |
| Degree of protection | IP67 |
| No. of cable outlets | 1 |
| Overvoltage category | II |
| Signal type/category | PROFINET CAT5 (based on IEC 11801), 100 Mbps |
| Standard designation | M12 connector |
| Insulation resistance | ≥ 100 MΩ |
| Material of grip body | Zinc die-cast, nickel-plated |
| Contact carrier material | PA 6 |
| Contact surface material | Ni/Au |
| Standards/specifications | according to IEC 61076-2-101 |
| Insertion/withdrawal cycles | ≥ 100 |
| Connection cross section AWG | 23 ... 22 |
| Material for screw connection | Brass, nickel-plated |
| Ambient temperature (operation) | -40 °C ... 85 °C |
| Flammability rating according to UL 94 | V0 |
Technical specifications and performance data
Installation and operation guide