

| Parameter | Value |
|---|---|
| 0.14 mm² ... 0.75 mm² (with ferrule) | |
| Width | 20 mm |
| Coding | B |
| Height | 20 mm |
| Length | 62 mm |
| Shielded | yes |
| Application | Data |
| Head design | Plug |
| Sensor type | PROFIBUS |
| Product type | Circular connector (cable-side) |
| Assembly note | NOTE:Observe the permissible bending radii when routing cables, since the degree of protection may be at risk if the bending forces are too high. Reduce mechanical loads upstream of the connector, e.g., by using cable ties. |
| Seal material | NBR |
| Article revision | 04 |
| Contact material | CuZn |
| Diameter housing | 20 mm |
| Head thread type | M12 |
| Outside diameter | 6.5 mm ... 8.5 mm |
| Connection method | Screw connection |
| Head cable outlet | straight |
| Tightening torque | 0.4 Nm (M12 knurl) |
| Contact resistance | ≤ 3 mΩ |
| Nominal current IN | 4 A |
| Nominal voltage UN | 48 V AC |
| Degree of pollution | 3 |
| Dimensional drawing | |
| Number of positions | 5 |
| Pg screw connection | Pg9 |
| Rated surge voltage | 1.5 kV |
| Degree of protection | IP67 |
| No. of cable outlets | 1 |
| Overvoltage category | II |
| Signal type/category | PROFIBUS |
| Standard designation | M12 connector |
| Insulation resistance | ≥ 100 MΩ |
| Material of grip body | Zinc die-cast, nickel-plated |
| Connection cross section | 0.25 mm² ... 0.75 mm² (without ferrule) |
| Contact carrier material | PA 6.6 |
| Contact surface material | Au |
| Standards/specifications | IEC 61076-2-101 |
| Insertion/withdrawal cycles | ≥ 100 |
| Connection cross section AWG | 24 ... 18 (without ferrule) |
| Material for screw connection | Zinc die-cast, nickel-plated |
| Ambient temperature (operation) | -40 °C ... 85 °C (Plug / socket) |
| Flammability rating according to UL 94 | HB |
| Stripping length of the individual wire | 5 mm |
Technical specifications and performance data
Installation and operation guide