

| Parameter | Value |
|---|---|
| The wires can be connected both with ferrules and without ferrules | |
| Coding | A |
| Length | 49 mm |
| Shielded | no |
| Head design | Socket |
| Sensor type | Universal |
| Cable outlet | angled |
| Product type | Circular connector (cable-side) |
| Assembly note | NOTE:Observe the permissible bending radii when routing cables, since the degree of protection may be at risk if the bending forces are too high. Reduce mechanical loads upstream of the connector, e.g., by using cable ties. |
| Seal material | NBR |
| Article revision | 01 |
| Contact material | CuSn |
| Diameter housing | 19 mm |
| Head thread type | M12 |
| Outside diameter | 4 mm ... 8 mm |
| Connection method | Push-lock spring connection |
| Head cable outlet | angled |
| Tightening torque | 0.4 Nm (M12 knurl) |
| Contact resistance | ≤ 5 mΩ |
| Nominal current IN | 4 A (2 A when using 0.14 mm² conductors) |
| Nominal voltage UN | 250 V AC |
| Degree of pollution | 3 |
| Dimensional drawing | |
| Number of positions | 4 |
| Rated surge voltage | 2.5 kV |
| Degree of protection | IP65 |
| No. of cable outlets | 1 |
| Overvoltage category | II |
| Signal type/category | Universal |
| Standard designation | M12 connector |
| Insulation resistance | ≥ 100 MΩ |
| Material of grip body | PA 6.6 |
| Connection cross section | 0.14 mm² ... 0.75 mm² (without ferrule) |
| Contact carrier material | PA 6.6 |
| Contact surface material | Ni/Au |
| Standards/specifications | IEC 61076-2-101 |
| Insertion/withdrawal cycles | ≥ 100 |
| Connection cross section AWG | 26 ... 18 (without ferrule) |
| Material for screw connection | Plastic |
| Ambient temperature (operation) | -40 °C ... 85 °C (Plug / socket) |
| Flammability rating according to UL 94 | V0 |
| Stripping length of the individual wire | 7 mm |
| Contact Color (signal designation) Contact (optional) | 1 = BN |
Technical specifications and performance data
Installation and operation guide