

| Parameter | Value |
|---|---|
| 0.2 Nm (M8 knurl) | |
| Coding | A |
| Length | 43.4 mm |
| General | NOTE:Observe the permissible bending radii when laying conductors, since the degree of protection may be put in jeopardy if the bending forces are too high. Alleviate mechanical loads upstream of the connector, e.g. by using cable ties. |
| Shielded | no |
| Head design | Plug |
| Cable outlet | straight |
| Product type | Circular connector (cable-side) |
| Seal material | NBR |
| Contact material | CuSn |
| Diameter housing | 12.5 mm |
| Head thread type | M8 |
| Outside diameter | 2.5 mm ... 5 mm ±0.2 mm |
| Connection method | Insulation displacement connection |
| Head cable outlet | straight |
| Tightening torque | 0.6 Nm (Pressure nut) |
| Contact resistance | ≤ 5 mΩ |
| Nominal current IN | 4 A |
| Nominal voltage UN | 60 V AC |
| Degree of pollution | 3 |
| Dimensional drawing | |
| Number of positions | 3 |
| Rated surge voltage | 0.8 kV |
| Degree of protection | IP65 |
| No. of cable outlets | 1 |
| Overvoltage category | II |
| Standard designation | M8 connector |
| Insulation resistance | ≥ 100 MΩ |
| Material of grip body | PA 6 |
| Connection cross section | 0.25 mm² ... 0.5 mm² |
| Contact carrier material | TPU GF |
| Contact surface material | Ni/Au |
| Standards/specifications | IEC 61076-2-104 |
| Wire insulation material | PVC / PE / PP / rubber |
| External cable diameter () | 2.5 mm ... 5 mm |
| Insertion/withdrawal cycles | ≥ 100 |
| Connection cross section AWG | 24 ... 20 |
| Material for screw connection | Stainless steel 1.4305 |
| Ambient temperature (operation) | -25 °C ... 80 °C (Plug / socket) |
| Flammability rating according to UL 94 | HB |
Technical specifications and performance data
Installation and operation guide