

| Parameter | Value |
|---|---|
| 6 mm | |
| Coding | A |
| Shielded | no |
| Head design | Pin |
| Thread type | M12 |
| Product type | Circular connectors (device side) |
| Test voltage | 1.5 kV |
| Assembly note | With locking nut |
| Mounting type | Rear mounting Pg9 With locking nut |
| Seal material | FKM |
| Article revision | 06 |
| Contact material | CuZn |
| Head thread type | M12 |
| Connection method | Solder pins |
| Head cable outlet | straight |
| Tightening torque | 3 Nm ... 4 Nm (Installation-side) |
| Contact resistance | ≤ 3 mΩ |
| Nominal current IN | 4 A |
| Nominal voltage UN | 60 V |
| Notes on operation | The electrical and mechanical data specified assume that the connector pair is correctly locked and mounted. If the connector is unlocked and if there is a danger of contamination, the connector must be sealed using a protective cap > IP54. Influences arising from litz wires, cables or PCB assembly must also be taken into consideration. |
| Order information: | Lock nut is included in the scope of delivery |
| Degree of pollution | 3 |
| Number of positions | 5 |
| Rated surge voltage | 1.5 kV |
| Degree of protection | IP65/IP67/IP69/IP69K |
| Overvoltage category | II |
| Standard designation | M12 connector |
| Insulation resistance | ≥ 100 MΩ |
| Contact connection type | Pin |
| Contact carrier material | PA 6.6 |
| Contact surface material | Au |
| Length of the solder pin | 6 mm |
| Standards/specifications | IEC 61076-2-101 |
| Insertion/withdrawal cycles | > 100 |
| Material for screw connection | Stainless steel |
| Ambient temperature (operation) | -40 °C ... 85 °C (cable, fixed installation) |
| Flammability rating according to UL 94 | V0 |
Technical specifications and performance data
Installation and operation guide