

| Parameter | Value |
|---|---|
| • WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible. | |
| Coding | A |
| Shielded | no |
| Cable type | PVC litz wire |
| Head design | Socket |
| Safety note | WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property. |
| Sensor type | Universal |
| Thread type | M12 |
| Cable length | 0.5 m |
| Product type | Circular connectors (device side) |
| Assembly note | With flat nut |
| Mounting type | Rear mounting Pg9 With flat nut |
| Seal material | FKM |
| Article revision | 11 |
| Contact material | CuZn |
| Head thread type | M12 |
| Connection method | Individual wires |
| Head cable outlet | straight |
| Head locking type | SPEEDCON |
| Tightening torque | 2 Nm ... 3 Nm (Installation-side) |
| Conductor material | Tin-plated Cu litz wires |
| Nominal current IN | 4 A |
| Nominal voltage UN | 60 V |
| Notes on operation | The electrical and mechanical data specified assume that the connector pair is correctly locked and mounted. If the connector is unlocked and if there is a danger of contamination, the connector must be sealed using a protective cap > IP54. Influences arising from litz wires, cables or PCB assembly must also be taken into consideration. |
| Order information: | Lock nut is included in the scope of delivery |
| Single wire, color | black, brown,blue, white, gray |
| Cable cross section | 0.5 mm² |
| Degree of pollution | 3 |
| Number of positions | 5 |
| Degree of protection | IP67 (When plugged in) |
| No. of cable outlets | 1 |
| Overvoltage category | III |
| Signal type/category | Universal |
| Standard designation | M12 connector |
| Conductor cross section | 0.5 mm² |
| Contact connection type | Socket |
| Contact carrier material | PA 6.6 |
| Contact surface material | Au |
| Material wire insulation | PVC |
| Standards/specifications | IEC 61076-2-101 |
| Insertion/withdrawal cycles | > 100 |
| Material for screw connection | Zinc die-cast, nickel-plated |
| Wire diameter incl. insulation | 1.8 mm |
| Flammability rating according to UL 94 | V0 |
Technical specifications and performance data
Installation and operation guide