

| Parameter | Value |
|---|---|
| IP67, when in locked state | |
| Note | In line with |
| Material | Zinc die-cast (nickel-plated) |
| Head design | Pin |
| Thread type | M12 |
| Product type | Panel mounting base |
| Assembly note | Spacing between the top edge of the PCB and the back of the front plate: 7 mm |
| Mounting type | Rear mounting M15 x 1 Spacing between the top edge of the PCB and the back of the front plate: 7 mm |
| Seal material | FKM |
| Article revision | 04 |
| Head thread type | M12 |
| Connection method | THR solder connection |
| Head locking type | SPEEDCON |
| Tightening torque | 1.5 ... 2 Nm |
| Notes on operation | The electrical and mechanical data specified assume that the connector pair is correctly locked and mounted. If the connector is unlocked and if there is a danger of contamination, the connector must be sealed using a protective cap > IP54. Influences arising from litz wires, cables or PCB assembly must also be taken into consideration. |
| Order information: | Lock nut is included in the scope of delivery |
| Degree of protection | IP67 (correctly plugged in and locked) |
| Standard designation | M12 connector |
| Standards/specifications | IEC 61076-2-101 |
| Insertion/withdrawal cycles | > 100 |
| Ambient temperature (operation) | -25 °C ... 85 °C (Plug / socket) |
| Degree of protection (when plugged in) | IP67 (correctly plugged in and locked) |
Technical specifications and performance data
Installation and operation guide