G89205517709

Smoke DetectorTypeG8920 5517 709Duline®FieldbusInstallationbus• Smoke detector using Tyndall effect• Detection of smouldering fires and flaming fires with smoke development• Without radioactive sources• Detection of up to 60 m2• Transmission of alarms and Alive signal via Dupline®• Operating voltage supplied by Dupline®bus• Optional use of the smoke detector as alarm device for other detectors such as gas, water and burglary via Dupline®• Battery backup if the Dupline®connection is interrupted• Acoustic alarm > 85 dB• Constant monitoring of sensor sensitivity via Dupline®Product DescriptionOrdering KeyG8920 5517 709The G89205517709 smoke detector allows early detec- tion of smouldering fires as well as flaming fires that develop smoke. It operates on the proven light scatter principle. Inside the sensing chamber, a light source and a light sensor are arranged so thatlightnormally doesSmoke alarms and Alive signal are transmitted via the Dupline®bus.Besides alarms, the built-in LED also shows the opera- tional status of the device. A test button allows a manual check of the alarm function, while simultaneously an alarm is given via theType: Dupline®TypeTypeSelectionOrdering no.G8920 5517 709Supply Specificationsnotfall on the sensor. It isDupline® bus.Optionaluseonly when airborne particles enter the chamber that light is scattered onto the sensor (Tyndalleffect)toproduce the electrical signal. This design means that no radioactive source is required.of the smoke detector as alarm device for other detectors such as gas, water and burglary via Dupline®.SupplySupplied by Dupline®Current consumption typ.2.5 mA Battery current consumption20 µASupply voltage9 VDCCurrent consumptionwhen alarm is active 10 mAInputSpecificationsDetector Optical (Tyndall effect)Response level According to EN 12239 (95)General SpecificationsChannel programmingVia GAP 1605 and special cable GAP-TPH-CABChannel assignmentI/O number 1 Alarm signal.Choose between active high or active low sensor. See manual for G3800xxxx about how to use this option.I/O number 2 Monitoring of sensor (tam- per/presence). The signal is always active if OK, other- wise inactive.I/O number 3 Monitoring of battery voltage.The signal is active if the voltage is low.General Specifications (cont.)I/O number 4 Monitoring of sensor sensitivity.The signal is active if the sensor becomes dirty.I/O number 5 Forced alarm.The smoke sensor can be used as an alarm device for e.g. water, gas and burglar alarms.Fail-Safe mode If the Dupline® connection is interrupted, the smoke sen- sor will still work, but as a normal individual smoke detector.Indication Red LED (short flash once every 42 sec. (alive signal): The smoke detector is OK. Short flash every 0.5 sec.: Alarm.Red flash (42 sec.) and simultaneous beep = Low battery voltage.Red flash (42 sec.) and asynchronous beep = DirtySpecifications are subject to change without notice (02.05.2011) 1Dupline®is a registered trademark. A product of the CARLO GAVAZZI Group