


| Parameter | Value |
|---|---|
| Fiber amplifierconnector | |
| Item | Functions |
| Shape | Type |
| Functions | Power tuning |
| Pre-wired | AND/OR output |
| NPN output | PNP output |
| I/O settings | Output setting (select from channel 2 output, AND, OR, leading edge sync, falling edge sync, or differential output) |
| Response time | Super-high-speed mode |
| Standard mode | 1 ms for operation and reset respectively |
| Timer function | Select from OFF-delay, ON-delay, or one-shot timer.1 ms to 5 s (1 to 20 ms set in 1-ms increments, 20 to 200 ms set in 10-ms increments,200 ms to 1 s set in 100-ms increments, and 1 to 5 s set in 1 s-increments) |
| Digital displays | Select from the following: Incident level for channel 1 + incident level for channel 2, Incident level + threshold, incident level percentage + threshold, incident light peak level + no incident light bottom level, minimum incident light peak level + maximum no incident light bottom level, long bar display, incident level + peak hold, incident level + channel |
| Protective circuits | Power supply reverse polarity protection, output short-circuit protection, mutual interference prevention |
| Sensitivity setting | Teaching and digital up/down keys |
| Degree of protection | IEC 60529 IP50 (with protective cover attached) |
| High-resolution mode | 4 ms for operation and reset respectively |
| Power supply voltage | 12 to 24 VDC±10%, ripple (p-p) 10% max. |
| Fiber amplifier connector1 | AND/OR output |
| Light source (wave length) | Red LED (650 nm) |
| 30 cm PVC cable with M8 plug connector (4 pin) | E3X-CN21-M3J-2 0.3M |
Technical specifications and performance data
Installation and operation guide